Selected subtotal: $2.04. Standard US shipping is $9.99 below $15, $7.99 from $15 to below $49, and free at $49 after discounts. Freight items excluded; other rates are shown at checkout.
IN STOCK
✓SAME-DAY DISPATCH — ELIGIBLE IN-STOCK ORDERS BY 2 PM ET
✓STANDARD US SHIPPING — $9.99 BELOW $15 · $7.99 FROM $15 · FREE AT $49 AFTER DISCOUNTS
✓LOCAL PICKUP — FALL RIVER
✓NET-30 & PO — APPROVED ACCOUNTS
CHIP BRUSHES
Documented Richard specifications
official product or family name
CHIP BRUSHES
PRODUCT FIT · IS THIS THE RIGHT TOOL?Straight answers. If it's the wrong tool for your job, we'll say so.
The guidance below describes applications and limitations. For a match to your particular job or an existing tool, ask us to confirm fit.
It is slow across a countertop or a slab door (step to the 2″/3″/4″) and clumsy inside a copper fitting or a single molding bead (step down to the 1/2″).
It cannot lay a showing finish coat — loose bristle and brush marks — and it is a poor latex brush because natural bristle goes limp in water.
For a small finished touch-up that must disappear, use foam (zero marks, if the coating is waterborne or oil, not lacquer) or an artist brush, not a chip.
the 1″ face is meant to cover a 3/4″–1″ edge or a small face in a single controlled stroke — load a third of the bristle, wipe one side, and lay it, rather than scrubbing back and forth. Hold the work: this is a two-handed size — the piece in one hand, the brush in the other — so the brush follows the part, not a bench layout. One material per brush: glue, primer, stripper, and solvent each get their own; the brush is too cheap to risk cross-contamination. Disposal: oil-, solvent-, and stripper-laden bristle is a self-heating hazard — dry flat and separated or drown in a sealed metal can, never bagged wet.
Asked before buying
BUYER QUESTIONS, ANSWERED BEFORE YOU ORDER
What's the 1″ chip best at?
Edges and small parts — edge-banding, a plywood edge, a small glue-up, a one-board primer touch — with a brush you throw out before the material cures (§2a, §2b).
Difference from the 1/2″ and the 2″?
The 1/2″ is for slots, fittings, and beads; the 2″ is for fields; the 1″ sits between, sized to an edge or a small face (§5).
Can I clean and keep it?
It's a consumable — the solvent and time to clean cost more than the brush; reuse only for a second pass of the same material (§3).
Will it leave bristles in my glue?
When new it can — break it in first (§2e).
Small finished touch-up?
Use foam or an artist brush; a chip sheds and marks (§4).
