Selected subtotal: $13.28. Standard US shipping is $9.99 below $15, $7.99 from $15 to below $49, and free at $49 after discounts. Freight items excluded; other rates are shown at checkout.
IN STOCK
✓SAME-DAY DISPATCH — ELIGIBLE IN-STOCK ORDERS BY 2 PM ET
✓STANDARD US SHIPPING — $9.99 BELOW $15 · $7.99 FROM $15 · FREE AT $49 AFTER DISCOUNTS
✓LOCAL PICKUP — FALL RIVER
✓NET-30 & PO — APPROVED ACCOUNTS
4" FlipBit™ Stainless Steel Joint Knife
Official Hyde specifications
Durable nylon handle
Pivoting #2 Phillips screwdriver included in handle
Rust-resistant, stainless steel blade
Desired flex point
PRODUCT FIT · IS THIS THE RIGHT TOOL?Straight answers. If it's the wrong tool for your job, we'll say so.
The guidance below describes applications and limitations. For a match to your particular job or an existing tool, ask us to confirm fit.
Seam tape coats on long flat joints as a primary knife — 4" can bed tape (better than the 3"), but full-room taping wants 4–6" dedicated joint knives run in sequence, not a screwdriver knife.
Driving structural fasteners — the in-handle bit is for cover-plate screws.
Fill and skim coats over seams — wide taping-knife work.
Scraping — flexible finishing blade, not a scraper.
Setting popped nails — no Hammer Head® butt; the FlipBit™'s integration is a screwdriver.
How the pros run it
01
The blade is a 4" flexible joint knife and works like one
bed tape with a thin film left under it, wipe from the center of a corner run outward, steer pressure to the blade's center so the corners float, load low and wipe firm. Stainless, so no drying ritual. For the bit: seat it fully before turning to avoid stripping a plate screw, and treat it as a cover-plate driver — a knife handle is a short lever, not a power driver's grip. And the standing safety rule the plate job lives under: cut the power before any device plate comes off.
Asked before buying
BUYER QUESTIONS, ANSWERED BEFORE YOU ORDER
What's the screwdriver for?
Removing and re-hanging cover plates (#2 Phillips), so one tool takes the plate off, finishes the wall, and puts it back.
How's it different from the 3" FlipBit™?
More finishing blade — the 4" can bed tape and work a corner; the 3" is more spot-and-patch.
Who was it for?
Repair, maintenance, and remodel work around live devices — not new-construction taping.
Does it set nails?
No — its integration is a screwdriver, not a Hammer Head® setter.
Still made?
No — the FlipBit™ 01945 is discontinued. For a current 4" stainless joint knife see the 01540.
